IOX-OUTPUT Triggered based on Speed Event using custom parameter
Customizeable Minimum speed for Harsh Cornering using custom parameter
Support for Make, Model & Serial Number data from engine, transmission and brakes (J1939 only)
NFC - Clear DriverID based on Auxiliary trigger using 2 custom parameters
Fuel level support for vehicles with 2 fuel tanks
Reduced required number of satellites for navigation to 4
Addition of record type for WWH-OBD and vehicle manufacturer specific Faults
Additional Gear detect support
Authorized Driver ID 'whitelist' support
IOX-BT support
Enhanced security measures and improvements
Improved S&F failover efficiency
External Device integration via IOX-USB
DPF and DEF level data support for OBD2 and WWH protocols
Enhanced protocol support (including WWH-OBD)
Engine Snapshot data improvements
Improved VIN detection logic
Diesel Fuel for vehicles in European market
Various Seatbelt and ODO improvements
Various Fuel/Diesel improvements
More detailed information on Released features and access to the historic changelog is available in the Firmware Release notes, please visit: https://goo.gl/4vr0dO
GO7 & GO6 - Development Firmware - 107.14.31+/109.14.31+/111.14.31+ & 102.14.31+
Key Features:
Various Fuel and Engine Data improvements
Improvements for Outside Temperature logging
Binary Data Support
Support for ECU Make and Model
Doran Trailer (TPMS) Support
Support for Vario Fault data
Support for Barometric Pressure (J1939)
Various seat belt and odometer improvements
Various fuel/diesel improvements
More detailed information on Beta features and improvements is available in the ‘What’s Coming’ section in the Firmware Release notes, please visit: https://goo.gl/4vr0dO
If you would like to run this version on your devices please enrol into the ‘Beta Program’. For more information on the ‘Beta Program’ please visit: https://goo.gl/Tki5xk
GO5 & GO4V3 Firmware Versions
GO5 - Release Firmware - 100.9.84
Key Features:
Clear Seatbelt State at start of every trip to ensure exceptions aren't carried over
Add GO Device Total Fuel Used and Total Idle Fuel Used status data
Use a combination of the accelerometer data and the GPS position to validate GPS speed
Enhanced Seatbelt Validation
APN based on location -- more APNs supported
Enhanced Remote Scan Tool Capabilities
Engine bus into listen-only mode as soon as GM detected
Added DEF level
Enhanced Intermittent Connection Logic
GO4v3 Live/Wi-Fi - Release Firmware - 81.6.84
Key Features:
Clear Seatbelt State at start of every trip to ensure exceptions aren't carried over
Additional HOS Support
Add GO Device Total Fuel Used and Total Idle Fuel Used status data
Use a combination of the accelerometer data and the GPS position to validate GPS speed
Enhanced Seatbelt Validation
APN based on location -- more APNs supported
Enhanced Remote Scan Tool Capabilities
Ability to extend immobilisation off delay to 40 minutes
Enhanced Intermittent Connection Logic
GO4v3 RF - Release Firmware - 82.2.20
Key Features:
Remove excessive warning lights when the GMLS harness is used
Resolve rare issue where unit may reset when entering low power mode
Improved GPS filter algorithm to prevent invalid GPS speeds
Engine bus into listen-only mode as soon as GM detected
